In vitro abrasivity and chemical properties of charcoal-containing dentifrices

Authors

  • Foteini Machla Nordic Institute of Dental Materials, Sognsveien, Norway
  • Aida Mulic Nordic Institute of Dental Materials, Sognsveien, Norway
  • Ellen Bruzell Nordic Institute of Dental Materials, Sognsveien, Norway
  • Håkon Valen Nordic Institute of Dental Materials, Sognsveien, Norway
  • Ida Sofia Refsholt Stenhagen Nordic Institute of Dental Materials, Sognsveien, Norway

DOI:

https://doi.org/10.1080/26415275.2020.1838284

Keywords:

Charcoal, dentifrice, abrasivity

Abstract

Objective

Charcoal-containing dentifrices are gaining popularity, but scientific information on their effect on oral health is scarce. This study investigated properties of dentifrices that may affect dentine abrasivity, as well as their ability to adsorb fluoride, their pH and the presence of harmful substances.

Materials and methods

The dentifrices NAO and COCO were subjected to the following analyses: abrasivity, expressed as mean abraded depth and relative dentin abrasivity (RDA), and surface roughness of extracted human molars (n = 30) after simulated brushing; fluoride adsorption measured as concentration change; pH measurements; detection of polycyclic aromatic hydrocarbons by gas chromatography–mass spectrometry. The products were compared to a reference dentifrice (Colgate® MaxWhite), positive controls (ISO dentifrice slurry, activated charcoal for laboratory use) and a negative control (distilled water).

Results

The mean abraded depths of NAO and COCO were not different (p > .05), but higher than the reference dentifrice and the negative control (p < .05). The RDA values of NAO, COCO and the ISO dentifrice slurry were higher than the reference dentifrice value (p < .05) by up to 10 times. The dentine surface roughness was higher after brushing with NAO, COCO and ISO dentifrice slurry compared to distilled water (p < .05). No change in mean adsorbed fluoride concentration was observed after 24 h (p > .05). Both NAO and COCO were alkaline (pH > 7). Analysis of NAO revealed the presence of naphthalene (112.8 ± 2.0 ng/mL).

Conclusion

The charcoal-containing dentifrices were abrasive within acceptable limits set by ISO and did not adsorb fluoride. The presence of naphthalene in one product is a cause for concern.

Downloads

Download data is not yet available.

Downloads

Published

2020-01-01

How to Cite

Machla, F., Mulic, A., Bruzell, E., Valen, H., & Refsholt Stenhagen, I. S. (2020). In vitro abrasivity and chemical properties of charcoal-containing dentifrices. Biomaterial Investigations in Dentistry, 7(1), 167–174. https://doi.org/10.1080/26415275.2020.1838284